Electromagnetic flowmeter sensor is a commonly used flow meter that can be used to measure the flow of liquids and gases.
1、 How to test the resistance of the electromagnetic flowmeter sensor?
Electromagnetic flowmeter sensor is a commonly used flow meter that can be used to measure the flow of liquids and gases. However, as the usage time increases, the sensor may malfunction. Below is an introduction on how to use a multimeter to test the resistance of an electromagnetic flowmeter sensor in order to determine its quality.
Firstly, select the resistance measurement mode of the multimeter and set it to test at different resistance ranges (usually between 0-200 ohms).
2. Then, connect the two electrodes of the sensor to the measuring probe of the multimeter (note that this is done with the power turned off).
If the sensor is functioning properly, the multimeter should display a stable resistance value. If the test results show abnormalities or are close to infinity, further inspection of the sensor is required.
2、 How to test if there is a short circuit in the electromagnetic flowmeter sensor?
Firstly, it is necessary to remove the electromagnetic flowmeter from the system and only handle the sensor part independently to prevent misoperation or injury.
2. Then, connect the two interfaces of the sensor with a simple circuit and test them with a multimeter.
If the test result is equivalent to zero, there may be a short circuit inside the sensor, which requires further inspection and repair.
3、 Observe whether the surface of the electromagnetic flowmeter sensor is damaged
If the surface of the electromagnetic flowmeter sensor is damaged, it may affect the accuracy and stability of the instrument. For example, when there are cuts or corrosion on the surface of the sensor, eddy currents may occur when the liquid flows, resulting in inaccurate measurement results.
In summary, the above are methods for judging the quality of electromagnetic flowmeter sensors, including using a multimeter to test resistance and short circuit conditions, observing whether the sensor surface is damaged, etc. If the above methods cannot solve the problem, it is recommended to go to a professional and formal maintenance site for inspection or replacement.
The thermal mass flow meter is designed based on the principle of thermal diffusion. The instrument uses the constant temperature difference method to accurately measure the gas. It has the advantages of small size, high degree of digitization, convenient installation and accurate measurement. Reduce your energy costs and increase your sustainability. Monitor your consumption and analyze your leakage flows with just one measuring device.
Mass Flow Meter is a new type of advanced flow measurement instrument and has been rapidly developed in the world. It has been widely used for process detection and custody transfer measurement in many industries such as petroleum, petrochemical, chemical, pharmacy, marine, pharmaceutical, municipal, paper, food and energy and so on. It has been highly valued by the flow research community and welcomed by users at home and abroad.
SUP-1158S Wall mounted clamp on ultrasonic flow meter uses advance circuit design,coupled with excellent hardware designed in English and can be switched surfaces.It is easy to operate and with stable performance.
SUP-2100H ultrasonic flow meter uses advance circuit design,coupled with excellent hardware designed in English and can be switched surfaces.It is easy to operate and with stable performance.
Hangzhou Economic Development Area，Hangzhou 310018，China
Supmea Co., Ltd. is a national high-tech enterprise engaged in the research and development, manufacturing, sales, and service of process automation instruments. Professional production of Magnetic flowmeter, Magmeter flow meter, Vortex flowmeter, Turbine flowmeter, Ultrasonic flowmeter, and Thermal mass flowmeter.
Copyright © Supmea Automation Co.,Ltd All rights reserved. contact